Punches

Line-up punch from Mayhew Tools at 14 inch length with 1/4 inch tip in alloy steel. Aligns bolt holes during structural and mechanical assembly work.

General Tools replacement point for No. 78 heavy duty automatic center punch. Wear part stocked across fabrication, machining, fleet maintenance, and industrial maintenance operations running center...

Drive pin punch measuring 4 inches with a 1/8 inch tip. The short punch drives pins, rivets, and roll pins out after starting, with hardened steel that resists mushrooming under the hammer. Used by...

Line-up punch from Mayhew Tools at 15 inch length with 1/4 inch tip in alloy steel. Aligns bolt holes during structural and mechanical assembly work.

Extra-long pin punch from Mayhew Tools at 8 inch length with 3/16 inch tip in alloy steel. Reaches into deep recesses for driving pins in equipment service.

General Tools heavy duty automatic center punch in steel construction. Spring-loaded mechanism marks center points without hammer strike for fabrication, machining, fleet maintenance, and industrial...

Line-up punch from Mayhew Tools at 9 inch length with 5/32 inch tip in alloy steel. Aligns bolt holes during mechanical assembly work.

Center punch from Mayhew Tools at 5 inch length with 3/16 inch tip in alloy steel unpolished finish. Marks center of holes before drilling in fabrication work.

Brass drift punch from Mayhew Tools at 8 inch length with 3/4 inch tip. Non-marring brass tip drives pins on finished surfaces without damaging steel.

Klein Tools wire rope punch with 1/2 Inch capacity. Used for crimping and installing wire rope ferrules across rigging, material handling, and industrial maintenance work.

Pin punch from Mayhew Tools at 4 inch length with 1/16 inch tip in alloy steel. Used for driving roll pins and dowel pins in equipment service work.

Center punch from Mayhew Tools at 4 inch length with 3/32 inch tip in alloy steel. Marks center of holes before drilling in fabrication and machine shop work.