Punches

Line-up punch from Mayhew Tools at 10 inch length with 3/16 inch tip in alloy steel. Aligns bolt holes during mechanical and structural assembly work.

General Tools automatic center punch measuring 5 Inch in steel construction. Spring-loaded mechanism marks center points without hammer strike across fabrication, machining, fleet maintenance, and...

Square head nail set measuring 4 inches with a 1/32 inch tip in alloy steel. The set drives finish nails below the surface for filling, and the square head resists rolling and gives a sure hammer...

Line-Up Punches - Economy Finish, 10 in, 3/16 in Tip, Alloy Steel

Automatic center punch measuring 5 inches with a 5/8 inch tip in an aluminum body. The spring mechanism strikes the point without a hammer to mark layout and start drill bits on center. Adjustable...

Pilot Punches - Series 112, 3-1/4 in, 5/64 in Tip, Alloy Steel

Line-up punch from Mayhew Tools at 10 inch length with 7/32 inch tip in alloy steel. Aligns bolt holes during mechanical and structural assembly work.

Proto J473/8X3/16 drive pin punch at 5-7/8 inch length with 3/16 inch tip in tool steel. Pin punch drives roll pins and dowel pins from mechanical assemblies during disassembly and service work. Used...

Drive pin punch measuring 4 inches with a 1/16 inch tip. The short punch drives small pins, rivets, and roll pins after a starter punch loosens them. Hardened steel resists tip mushrooming under the...

Klein Tools center punch with 6 Inch length, 1/2 Inch tip, and carbon steel construction. Layout and marking tool for fabrication, machining, and maintenance work.

Proto J963/4 drift punch with 3/8 inch tip at 10-1/8 inch length in tool steel. Drift punch drives bolts, rivets, and pins through mechanical assemblies during disassembly work. Hardened steel...

Pin punch from Mayhew Tools at 5-3/4 inch length with 1/4 inch tip in alloy steel. Used for driving roll pins and dowel pins in equipment service work.