CHISELS, PUNCHES & PINS

Line-up punch from Mayhew Tools at 10 inch length with 7/32 inch tip in alloy steel. Aligns bolt holes during mechanical and structural assembly work.

Proto J86A7/8X12 cold chisel with 1 inch cut at 12 inch length. Extended length supports cold cutting work where standard length chisels cannot reach. Hardened steel construction supports cold...

Cold chisel from Mayhew Tools at 8 inch length with 1 inch cut width in black oxide. Used for heavy cutting and shaping in fabrication and structural work.

Proto J473/8X3/16 drive pin punch at 5-7/8 inch length with 3/16 inch tip in tool steel. Pin punch drives roll pins and dowel pins from mechanical assemblies during disassembly and service work. Used...

Proto J86A3/16 cold chisel with 1/4 inch cut at 5 inch length. Hardened steel construction supports cold cutting of bolts, rivets, and metal stock during mechanical disassembly and fabrication work...

Drive pin punch measuring 4 inches with a 1/16 inch tip. The short punch drives small pins, rivets, and roll pins after a starter punch loosens them. Hardened steel resists tip mushrooming under the...

Klein Tools center punch with 6 Inch length, 1/2 Inch tip, and carbon steel construction. Layout and marking tool for fabrication, machining, and maintenance work.

Bi-material wood chisel with a 3/4 inch cutting edge and 9 inch length for chopping and paring wood. The bi-material handle absorbs mallet impact and resists splitting through heavy use. The hardened...

Proto J86A7/8X8 cold chisel with 1 inch cut at 8 inch length. Hardened steel construction supports cold cutting of heavy bolts, rivets, and metal stock during mechanical disassembly and fabrication...

Proto J963/4 drift punch with 3/8 inch tip at 10-1/8 inch length in tool steel. Drift punch drives bolts, rivets, and pins through mechanical assemblies during disassembly work. Hardened steel...

Klein Tools barrel-type drift pin with 15/16 Inch diameter and 8 Inch length. Ironworker drift pin for aligning structural steel bolt holes across fabrication and erection work.

Pin punch from Mayhew Tools at 5-3/4 inch length with 1/4 inch tip in alloy steel. Used for driving roll pins and dowel pins in equipment service work.