Empire Level

Carpenter's framing square in steel, 8 by 12 inches with 1/8 inch thickness. Used for layout, marking 90 degree angles, and roof framing calculations.

1000 ft roll of safety barricade tape, 3 inches wide in red with Danger Do Not Enter legend. Used by contractors and facility crews to mark off restricted work zones.

Steel framing square at 16 by 24 inches. Standard layout square for carpenters and framers handling wall and roof framing measurements.

16 by 24 inch aluminum framing square. Lighter than steel for jobsite layout work in framing, roofing, and concrete forming.

Heavy-duty 16 by 24 inch anodized aluminum framing square. Anodized finish resists corrosion in outdoor jobsite work.

8 inch Polysteel try square with built-in level vial. Combines 90 degree layout with level reference for carpentry and cabinetmaking work.

8 inch True Blue try square in heavy-duty aluminum with stainless steel blade. Used by carpenters and cabinetmakers for marking 90 degree layouts on lumber and panel stock.

Polysteel T-bevel with 9 inch adjustable stainless steel blade. Transfers existing angles for carpentry, stair stringer layout, and cabinet work.

Heavy-duty stainless steel True Blue T-bevel with 10 inch adjustable blade. Transfers angles cleanly for carpentry, framing, and finish work.

ShieldTec non-detectable underground marker tape for gas lines. Buried over gas piping to warn excavators of the line below during future trenching work.

12 inch Polysteel combination square graduated in 1/16 inch. Used for 90 and 45 degree layout, depth measurement, and level checks on carpentry and metalwork.

Compass, 12 in, Steel